2008 Chevy Impala Key Fob Programming

Turn ignition to the on position for 5 seconds then back to off position.

2008 chevy impala key fob programming.

Insert an existing programmed working key into the ignition cylinder. 2008 chevrolet impala we strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on northcoast keyless. Yes once you have had the new key cut by a locksmith use the following instructions. To program additional remotes at this time repeat step 4.

Turn key off then back to on. Press the set reset button until remote key learning active displays press and hold the lock and unlock buttons on the keyless remote at the same time for approximatley 15 seconds. The instructions will not work for 2011 up vehicles. Free keyless fob procedures for your new or used replacement fob.

Chevrolet automotive remote programming instructions. The key is now programmed. 2008 chevrolet impala remote programming there are 2 possible procedures for this gm vehicle note. Insert an existing programmed working key into the ignition cylinder.

Turn ignition to the on position for 5 seconds then back to off position. This vehicle can have a maximum of eight remotes programmed. A chime will sound indicating that the remote is programmed. Remove the existing key and within 5 seconds insert new key and turn it to the on position for 5 seconds.

Press and hold the lock and unlock buttons on the keyless remote at the same time for approximatley 15 seconds. Keyless entry fob remote programming for all vehicles. Start vehicle to test key. The chevrolet impala has been manufactured throughout the 1990s and 2000s and today offers drivers the keyless entry remote system.

2011 up vehicles require dealer or locksmith programming only. Whether the system was installed with the car or purchased as an aftermarket option you can program or reprogram your remote in just minutes from the car. A chime will sound indicating that the remote is programmed. Insert the original already programmed key in the ignition and start the engine.