How To Hang A Rug With Fringe On The Wall

Next stretch it out left and right and place additional push pins there.

How to hang a rug with fringe on the wall.

Knot a decorative c. These gaps permit the use of additional brackets and prevent sagging. The second method of hanging an area rug on the wall involves the use of a curtain rod. Sew fabric to the top of the rug forming a tube.

This should be attached close to the top of the rug. Then pin the bottom. Repeat until the entire rug is covered in fringe. Attach anchors to the wall using a drill and screws.

Hot glue another strip about 1 2 to 1 depending on how dense you want the fringe to be above the last. To hang a round rug on the wall you would use push pins or command strips. Pass a bar through the strip and hang the rug. First cut the tape into 12 inch sections and attach the sections to the rug 1 2 inch apart.

Sew muslin to the top of the rug. This method allows you to hang a fringed rug on the wall without damaging it. Lift the rug and press it into the strap to attach it. This will serve as casing for your rod when hanging the rug.

Hanging heavy weight rugs. For extra support hammer nails into the corners. Put the top of the rug there and put a push pin or command strip there. First mark where you want the rug.

Attach the tape to the back of the rug in the same way as for a smaller rug. Hanging fringed rug on wall. Hanging fringed rug on wall hanging fringed rug on wall. The second method of hanging a rug should be used for large and heavy weight rugs.

Hot glue a strip of the cotton fringe right along the long bottom edge of your rug. Insert a suitable rod. Now add your contrasting fringe. To protect your rug from the wood and nails paint or seal the rug strip and let it dry completely.

Line up the carpet tack strips where you ll want to hang the rug and gently hammer the nails into the wall. Cut a piece of fabric the same width of your rug large enough to be able to form a tube that will snuggly fit the width of your rod. Cut a few small strips and lay them on top to decide where you want them. Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug.

Attach rod support the brackets to the wall aligned with the gaps in the. This method allows you to hang a fringed rug on the wall without damaging it. A heavy cotton casing may be sewn onto the back of the rug again this should be hand sewn if hanging a handmade or antique rug to form a tube through which the curtain rod may be inserted. Insert rod into the tube of fabric on the rug and hang the rod onto the wall.