How To Lay Laminate Flooring Over Hardwood

If you keep this in mind when you re laying the laminate floor installing the transition strips is easy.

How to lay laminate flooring over hardwood.

Can pergo laminate be installed over old existing hardwood floors. Secure the first row of planks traveling lengthwise along the wall. Avoid a narrow strip against the focal point wall. Planks in the last row should be at least 2 inches wide.

Snap a line between the marks on the starting wall to form a guideline along the starting wall. Snap the second board at the end of the first. Typically you nail the transition strips to the subfloor so you need a gap of about an inch between the two flooring materials. Hold the long side of the second row plank at an angle.

To decide which direction to lay the laminate wood floor planks consider which wall is the longest and straightest. Beginning at the longest wall put inch thick spacers between the wall and the first row of flooring. You are now ready to install laminate or hardwood flooring in your room or home. Use the remainder of the laminate flooring planks you cut at the end of row one to start the next row as long as it s.

Laminate flooring can be installed directly over hardwood often with no preparation necessary. Pergo made a big impact on the flooring market several years ago with its easy to install snap and lock installation and its. Press it against the expansion block. Start the second row where you started off the first.

You will lay the flooring lengthwise along this line. Lay the first hardwood plank on the glue with the groove facing the wall. Continue to the end of the wall using. Figure on a 1 4 inch gap at each wall.

This will stagger the seams which results in a more natural look. If your laminate has a built in underlayer you may install it right on top of the hardwood. Prepping a plywood subfloor for hardwood or laminate flooring introduction. If you forget to leave a gap you may be able to find transition strips that you can glue to the flooring.

If the new flooring does not have the built in underlayer simply roll out and tape your underlayment to the wood floor and begin installing the laminate. Turn the grooved edge of the plank toward the spacers. Check for flush by placing a straight edge against the tongue of the flooring.